5808W3, Honeywell Wireless Thermal Combined Smoke Detector
Price list of Honeywell Notifier fire alarm equipment 2020
⭐ Notifier Honeywell wireless smoke detector fire alarm device, Contact 0917.911.114
Honeywell's 5808W3 is a lithium-powered 3V photoelectric heat/smoke detector with a built-in wireless transmitter. It is designed for use with any 5800 Series Wireless Transmitter/Receiver for residential installations (for commercial installations, 5881ENHC or 5883H receiver is required). The transmitter can send alarms, tampering, maintenance (when the control panel is equipped to handle maintenance signals) and battery status messages to the system's receiver. Smoothing algorithms minimize nuisance alarms by smoothing short-term spikes dust and smoke - virtually eliminating nuisance alarms. Since there are no holes to drill or wires to run, you can preserve the beauty of the building while protecting it. The 5808W3 is an ideal smoke detector for locations where wiring is difficult, applications where room aesthetics are important, or where hazardous materials exist. All models also have a built-in, fixed-temperature probe (135°F) that is also capable of sensing pre-freeze if the temperature is below 41°F.
Strong RF field strength improvement, - The distance between the detector and the receiver has been significantly increased without the need for a repeater
Algorithm smoothing Mathematical calculations in detector software help reduce nuisance alarms by smoothing short-term spikes dust and smoke
Smart test - A signal is sent to the control panel when the detector requires cleaning. This allows for a regular, non-emergency service call to clean the detector before it goes alarm.
Drift compensation
- Eliminate nuisance alarms long-term dust accumulation by automatically adjusting detector sensitivity Removable probe cover and Chamber Head technicians can quickly and easily clean the probe chamber without disassembling the probe
UL approved list for applications residential and commercial Both residential and commercial installation requirements are met
Additional LED status indicators
- Identify between alarm or fault conditions is a snap with green and red LED status indicators. Blue LED indicates normal condition while red LED indicates abnormal condition. The easy-to-install, sturdy mounting base allows the probe to be more easily mounted on uneven surfaces (e.g. mortar). The mounting base has larger mounting ports that can anchor drywalls for easy surface mounting.
ADDITIONAL FEATURES:
- Uses a long life 3V lithium battery - Microcontroller runs on 4.0 MHz clock - Horn operates at 3.3 KHz with a sound pressure level of 85 dBA at 10 feet
- Built-in wireless transmitter, 3-sound timecode The maintenance signal is fully compliant with the sensitivity test requirement specified in NFPA 72, 7-2.2 and is UL approved
You can refer to products genuine fire alarm equipment...HERE
TVAdministratorsAdministrators