Strobe Light SLED177i
✅ The Kidde SLED177i, used in conjunction with a smoke, heat or carbon monoxide alarm, provides a bright visual signal to warn of a smoke, heat or CO hazard. The Kidde LED SLED177i light benefits the hearing impaired, allowing a visual alert of a danger. This unit also includes a tamper resist pin that helps to deter thief and tampering.
✅ The Kidde Strobe light benefits the hearing impaired, allowing a visual alert of a danger.
✅ This unit also includes a tamper resist pin that helps to deter thief and tampering.
✅ The Kidde SLED177i, used in conjunction with a smoke, heat or carbon monoxide alarm, provides a bright signal to warn of a smoke, heat or CO hazard.
The Kidde SLED177i (formerly SL177i) is a 120VAC wire in unit that provides a visual warning when part of an interconnected system. This unit can be directly interconnected with Kidde smoke alarms, heat alarms and carbon monoxide alarms (a maximum of 24 devices of which 18 can by initiating). When triggered by a smoke alarm or heat alarm, it will produce a steady flash warning. When triggered by a carbon monoxide alarm it will produce an intermittent flash warning. SLED177i has a 10 year limited warranty and is UL Listed.
ATTENTION! The model SLED177i LED strobe light is designed to notify hearing impaired individuals of impending danger, it has no detection means and MUST be used in conjunction with operating interconnected Smoke, Heat, or Carbon Monoxide Alarms.
Features
Bright LED Strobe Light – Flashes to warn of a smoke, heat or carbon monoxide event
Green LED – Indicates AC power is being delivered to the unit
UL Listed – Meets UL 1971 Standard
Interconnects with up to 24 Kidde devices (18 of which can be initiating)
Architectural and Engineering Specifications
The LED strobe light shall be Kidde Unit SLED177i or approved equal. It shall be powered by a 120VAC, 60Hz source. The temperature operation range shall be between 32°F and 120°F (0°C and 49°C). The LED strobe light can be installed on any standard single gang electrical box, up to a 4” octagon junction box. The electrical connection (to the device) shall be made with a plug-in connector. A maximum of 24 Kidde devices can be interconnected in a multiple station arrangement. The interconnect system must not exceed the NFPA (National Fire Protection Association) limit of 18 initiating devices (Smoke, heat, CO, etc) interconnected. With 18 initiating devices, it is still possible to interconnect 6 strobe lights and/or relay modules. The unit can be directly interconnected with Kidde Safety 3-wire Smoke, Heat and CO alarms. It will produce an intermittent strobe flash pattern (approximately 4 flashes, followed by approximately 5 seconds off) when triggered by a Carbon Monoxide alarm, and a flash every second when triggered by a smoke or heat alarm. The unit shall at a minimum meet the requirements of UL1971, NFPA72, the State of California Fire Marshall, NFPA101 (One and two family dwellings, Federal Housing Authority (FHA), Housing and Urban Development (HUD), Americans with Disabilities Act (ADA). The unit shall be UL Listed.
Installation of Strobe Light
The LED strobe light should be installed to comply with all local codes having jurisdiction in your area, Article 760 of the National Electric Code, and NFPA 72. Make certain all devices are wired to a single, continuous (non-switched) power line, which is not protected by a ground fault interrupter. A maximum of 1000 ft. of wire can be used in the interconnect system. Light output gradually decreases as viewing angle is increased. Consult chart in users guide to determine the best location for the strobe light installation.
Technical Specifications
Model: | SLED177i |
Power Source: | 120VAC, 60HZ |
Electrical Rating: | 96 - 132 VAC, 60HZ, 630 mA max |
Temperature Range: | 32 ̊F to 120 ̊F (0 ̊C to 49 ̊C) |
Flash Rate: |
Fire: Constant 1 flash per second CO: Intermittent 1 flash per second (4 flashes, 5 seconds off) |
Light Output | 177 Candela |
Size: | 5.6” in diameter x 3” depth |
Weight: . | 85 lb |
Interconnects: | Up to 24 Kidde devices of which 18 can be initiating devices. |
Warranty: | 10 year limited warranty |
Ordering Information
TVAdministratorsAdministrators