Sequence Starter AW-GD205
The Sequence Starter is designed to divide the valve signal output by the panel four to delay the trigger one by one. There are 9 LED indicators on the module. Among them, the green indicator is...
Sequence Starter Overview
The module is designed to divide the valve signal output by the panel four to delay the trigger one by one.
There are 9 LED indicators on the module. Among them, the green indicator is the power indicator. When the power is turned on,it will light up. In addition, each valve output has a red indicator and a yellow indicator. When the corresponding output circuit is triggered, the red indicator light of that group will light up. When a circuit fails, the circuit's fault indicator will light up.
Sequence Starter Mounting
AW-GD205 Sequence Starter should comply with all local codes. Shown in Figure 2, fix the base on the wall with screws, connect the corresponding wires, and re-tighten the screws on the shell.
The base dimensions of 125mm125mm40mm (LengthWidthHeight), mounting hole diameter φ4mm, fixing the hole spacing is 67mm
.png "Sequence Starter AW-GD205")
Sequence Starter Connection
1. The EM VALVE-1 to EM VALVE-4 are wiring to external electromagnetic valve.
Please pay attention to the polarity of the terminal when wiring, and it requires series connect a 1N4007 diode (or equivalent diode) between the [+] pole of the terminal output and the [+] pole of the electromagnetic valve input, and paralleled connect a 6.8K Ω/1W resistor in the end of the output circuit.
The terminal output current up to 2A, you shall pay attention not to exceed the limit current.
2. One of the other two terminals is connected to the control panel’s EM VALVE output terminal, and the other one is connected to the Resettable 24V output terminal.
.png "Sequence Starter AW-GD205")
Surface mounting
LED indicator
MCU intelligent control
Automatic fault detection
Connection via high-quality terminal blocks
6 Compatible with the latest standards
Technical
Operating voltage: 24VDC
Operating current: ≤25mA
Operating temperature: -10℃～55℃，Relative humidity: ≤95%(non-condensing) 3.4 Protection class: IP20
Application: For indoor use only
EM valve output current: 2A max
Materials and colors: SPCC, Red
Size: 125mm125mm40mm
.png "Sequence Starter AW-GD205")
You will receive a quote from us as soon as possible..
Related products
Have 0 comment, evaluate about Sequence Starter AW-GD205
TVAdministratorsAdministrators