Fire Alarm Control Panel FS4000 UNIPOS 2 4 6 8 ZONES
Fire control panel FS4000 is designed to operate with conventional automatic fire detectors and manual call points. The panel has outputs provided for external executive devices.
Description:
Fire control panel FS4000 is designed to operate with conventional automatic fire detectors and manual call points. The panel has outputs provided for external executive devices.
The unit is produced in four versions:
| 2 fire alarm lines | FS4000/2 |
| 4 fire alarm lines | FS4000/4 |
| 6 fire alarm lines | FS4000/6 |
| 8 fire alarm lines | FS4000/8 |
Performance:
- Control over fire alarm lines and controllable outputs for fault conditions (short circuit and interruption) and automatic reset.
- Detection of removed fire detector and automatic reset.
- Identification of manual call points.
- LED indication for alarm state and emergency.
- Delay of outputs for fire condition with time period of 1, 2, 3, 4, 5, 6 or 7 minutes after fire condition is registered.
- Option for ''LOGICAL AND '' realization of two fire alarm lines.
- Duty Mode condition with direct activation of Fire Condition 2nd Stage '' for two fire alarm lines.
- Status Indication of the device for data transmission RS485.
- Option for switching on/off interface RS485 communication.
- Built-in sounder for fire condition – one tonal, continuous, can be switched off.
- Built-in sounder for fault condition – one tonal, discontinuous, can be switched off.
- Test mode for fire alarm lines.
- Disabling fire alarm lines.
- Disabling outputs for fire condition.
- Expanding the options by means of extra relay outputs for fire condition for each line and built-in RS485 for operation in a local network.
TVAdministratorsAdministrators