Fire Alarm Device Coder And Fire Alarm Control Panel Programming Method
Fire Alarm Device Coder AW-CODER2188 is a portable device for writing/reading address code of all intelligent terminals our company products.
Overview Fire Alarm Device Coder And Fire Alarm Control Panel Programming Method
Fire Alarm Device Coder AW-CODER2188 is a portable device for writing/reading address code of all intelligent terminals our company products.
The fire alarm control panel is an important part of the fire alarm system. It can receive, display, transmit fire alarm signals, and issue the control signals.
What is the programming method of the fire alarm control panel?
Normally, there are three steps to program the fire alarm control panel:
1.Code the devices.
Do the device definition on the alarm controller according to the code of the device. Make it clear that what code corresponds to what device, and make descriptions of them.
2.Let the panel identify devices.
Let the fire alarm control panel identify the defined devices, and check the circuits of the devices that are not identified.
3.Edit device linkage logics.
After the fire alarm control panel identifies the devices, edit the device linkage logic relationship to determine the device action logic.
Above are the basic programming method of the fire alarm control panel. You can program the fire alarm control panel according to the 3 steps.
Features Fire Alarm Device Coder And Fire Alarm Control Panel Programming Method
Small size, shockproof and portable to take with;
Low power consumption, successive working duration is up to 18 hours;
Support 2100/9000 intelligent terminal;
Automatically increase the code based on previous, improve the work efficiency;
Battery level can be checked;
Over-discharge protection is provided;
Short circuit protection is provided;
Charging indicator is designed;
Automatically enter power saving mode and power off in idle mode.
Fire Alarm Device Coder And Fire Alarm Control Panel Programming Method
Technical parameters Fire Alarm Device Coder And Fire Alarm Control Panel Programming Method
Built-in 1600mAh lithium battery;
External 24V/500mA DC can be used as direct work power supply or to charge the battery;
Working current: 15mA—170mA, standby current: 15mA;
Ambient temperature: -20℃～60℃, relative humidity: 5%～95%.
Please see also AV lice press equipment HERE
TVAdministratorsAdministrators